1)bonding strength膠合強度
1.Formation process of bonding strength during wood gluing operation;木材膠接時膠合強度的形成過程
2.5 %,the PF adhesive with moderate viscosity had high bonding strength,and the bonding strength could achieve the demands of GB/T 9846-2004.實驗結果表明,竹焦油替代量對所合成的酚醛樹脂膠黏度和膠合強度特性影響較大,當竹焦油添加量為30 g,即替代量達到12。
3.The influence of different electro-conductive elements and adhesive spread on shielding and bonding strength of Larix plywood was investigated.以鎳粉、石墨粉、不銹鋼纖維和銅纖維作為導電單元,脲醛樹脂為膠黏劑,制備3層落葉松膠合板,研究不同導電單元和涂膠量對板材電磁屏蔽效能(ESE)及膠合強度的影響。
英文短句/例句
1.Plywood--Determination of glue bond strengthGB/T9846.12-1988膠合板膠合強度的測定
2.The Agglutination Intention’s Analysis on the Driving Gear of Circular Water Pump;循環水透平泵傳動齒輪膠合強度分析
3.The Design and Application of the Groove-Making Mould for Glue Bond Strength Test Pieces膠合強度試件制槽模具的設計與應用
4.Study on Bonding Strength Impacted by Roughness of Sanding Wood and Bamboo Surface木、竹材磨削粗糙度對膠合強度影響的研究
5.Effect on bonding strength of sanding surface roughness of wood and bamboo磨削木竹材表面粗糙度對膠合強度的影響
6.Testing methods for wood adhesives and their resins--Method for determination of wood glue bond strengthGB/T14074.10-1993木材膠粘劑及其樹脂檢驗方法木材膠合強度測定法
7.testing methods of wet gel strength for compounded latex合成膠乳的濕潤膠凝強度試驗方法
8.adhesion testing methods for vulcanized rubber硫化橡膠粘合強度的測定
9.Method of test for adhesive strength of sizesGB/T1742-1979膠液粘合強度測定法
10.Influence of Superplacticister and Redispersible Polymer Powder on the Strength of Crumb Rubber Mortar減水劑復合聚合物對橡膠水泥砂漿強度的影響
11.Gullibility: Measure of speed of paper adhesive bonding and its strength.膠粘性能:膠粘劑對紙品的粘合速度和強度的能力。
12.Rubber and plastics-Analysis of multi-peak traces obtained in determinations of tear strength and adhesion strengthGB/T12833-1991橡膠和塑料撕裂強度及粘合強度多峰曲線的分析方法
13.Rubber and plastics hose--Determination of adhesion between componentsGB/T14905-1994橡膠和塑料軟管各層間粘合強度測定
14." Rubber, vulcanized-Determination of adhesion to metal-Tension method"GB/T11211-1989硫化橡膠與金屬粘合強度的測定拉伸法
15." Rubber, vulcanized--Determination of adhesion to single wire--Pull out test"GB/T3513-1983橡膠與單根鋼絲粘合強度的測定抽出法
16.The freezing point of the modified bone glue produced by this technics is very low and the adhesive strength is very high.所得到的改性骨膠粘合劑凝固點低 ,粘結強度高
17.Shear Strength of Flip Chip Packaging Bonded with Anisotropic Conductive Film倒裝芯片各向異性導電膠互連的剪切結合強度
18.STUDY AND PERFORMANCE EVALUATION ON THE HIGH STRENGTH COMPOSITE GEL SYSTEM復合高強度凝膠體系的室內研究及性能評價
相關短句/例句
bond strength膠合強度
1.The study on bond durability of structural plywood for timber structures mainly consists in determination of bond strength and heat durability of plywood.木結構用膠合板膠合耐久性的研究,主要是對膠合強度和熱耐久性的測定。
2.The tea waste powder with different sizes as an additive was used to urea-formaldehyde (UF) resin, and the effects of the tea waste powder sizes and amount on the free formaldehyde content of UF resin, the formaldehyde emission, and bond strength of UF resin bonded plywood were studied in this paper.將不同顆粒度的茶葉廢料粉添加到脲醛樹脂膠中,研究了茶葉廢料的顆粒度、加入量等對脲醛樹脂膠黏劑的游離甲醛含量、黏接膠合板的甲醛釋放量及膠合強度的影響。
3.The urea and two active compounds were concentrated to prepare ULR resin,and the ULR resin as an adhesive for plywood was studied by manufacturing plywood,testing its bond strength,and measuring its formaldehyde emission.結果表明:一定反應條件下,反應時間對ULR樹脂的粘度影響不大;面粉添加量對ULR樹脂膠接膠合板的膠合強度影響較大;當反應時間為120min、面粉添加量為15%時,ULR樹脂膠接膠合板的膠合強度能夠滿足國家標準(≥0。
3)shear strength膠合強度
1.The influence of different spreading and length of CF on electromagnetic- shield effectiveness and shear strength(ST)of Larix composite plywood was researched.為了賦予木基復合材料電磁屏蔽功能,在脲醛樹脂膠中加入黃銅纖維導電單元,制備三層結構的落葉松復合膠合板,研完不同施加量和不同長度的導電單元以及涂膠量對木基復合材料電磁屏蔽性能(SE)和膠合強度(ST)的影響。
2.The influence of different electro-conductive element spreading and hybrid type on electromagnetic-shield effectiveness and shear strength(ST)of Larix plywood was researched.以不銹鋼纖維(SF)、黃銅纖維(CF)、超細鎳粉(Ni)以及石墨粉(CP)為導電單元,采用纖維與粉末、不銹鋼纖維與黃銅纖維混和方式,在脲醛樹脂膠中加入混和導電單元制備3層結構的落葉松膠合板,研究導電單元不同施加量以及混和方式對木基復合材料電磁屏蔽性能(SE)和膠合強度(ST)的影響。
3.The influence of different spreading and length of SF on electromagnetic-shield effectiveness and shear strength (ST)of Larix composite plywood was researched.為了賦予木基復合材料電磁屏蔽功能,在脲醛樹脂膠中加入不銹鋼纖維(SF)導電單元,制備三層結構的落葉松復合膠合板,研究不同施加量和不同長度的導電單元以及涂膠量對木基復合材料電磁屏蔽性能(SE)和膠合強度(ST)的影響。
4)adhesive strength膠合強度
1.Moreover,The modified UF resin have characteristics of lower content in free formaldehyde and simple craft in production;The adhesive strength and formaldehyde release of plywood produced with this resin are all accord wi.羧基丁苯膠乳改性脲醛樹脂膠粘劑具有游離甲醛含量低、生產工藝簡單等特點,生產出的膠合板的膠合強度和甲醛釋放量均滿足國家標準。
5)Plywood--Determination of glue bond strength膠合板 膠合強度的測定
6)internal bond strength內部膠合強度(林)
延伸閱讀
表光合強度(見光合強度)表光合強度(見光合強度)forecast of sowing or transplanting time b iaoguanghe qiangdu表光合強度見光合強度
